Steam Functions (Steam Models) - LG DLE3170 Serie Manuel Du Propriétaire

Steam Functions (Steam
Models)
Filling the Steam Feeder
Before using a Steam Cycle, the steam feeder must
be filled with water up to the filter screen. If not, an
error message will be displayed. Make sure that the
steam feeder is filled with water and the drawer is
fully closed. Turn the dryer off and then restart the
Steam Cycle.
1
Pull out the drawer.
2
Lift out the steam feeder.
3
Fill the steam feeder just to the filter screen.
4
Place the steam feeder in the drawer; then push
in the drawer until it clicks into place.
WARNING
To reduce the risk of serious injury or death,
follow basic precautions in the following:
• Do not fill the steam feeder with liquids such
as gasoline, dry-cleaning solvents, or other
flammable or explosive substances.
• Do not drink water from the steam feeder.
NOTE
• An error message may be displayed even after
you fill the steam feeder with water up to the filter
screen. Fill the feeder again with water up to the
filter screen.
• Only use tap water. Do not fill the steam feeder with
foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam
feeder is empty.
• Do not use distilled water; the water level sensor in
the steam generator will not work.
• Use care when you put back the Steam Feeder that
may overflow with water.
• Wipe up any spilled water around the Steam Feeder
and the drawer before starting the dryer.
• Do not fill the steam feeder with hot water (over
86°F/30°C).
Filter screen
OPERATION 37