Error Code - LG DLE3170 Serie Manuel Du Propriétaire

24 INSTALLATION
Check the Duct Condition
If the Flow Sense™ LED is turned on, check the
exhaust system for restrictions and damage. Repair
or replace the exhaust system as needed.
NOTE
• When the dryer is first installed, this test should be
performed to alert you to any existing problems with
the exhaust duct in your home. However, since the
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than the installation test, the number
of bars displayed during the two tests may not be
the same.
• Do not interrupt the test cycle, as this could result in
inaccurate results.
• Even if no bars are displayed during the test cycle,
some restrictions may still be present in the exhaust
system. Refer to the Venting the Dryer section
of this manual for complete exhaust system and
venting requirements.
• Your dryer features Flow Sense™, an innovative
sensing system that automatically detects
blockages and restrictions in the dryer ductwork.
Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces
energy use.

Error code

Check the error code before you call for service.
Error Possible
Code Causes
tE1 or Temperature
tE2 sensor failure.
Humidity sensor
HS
failure.
Electric dryer
power cord is
not connected
correctly, or
house power
supply is
incorrect.
PS,
PF, or
nP
House fuse is
blown, circuit
breaker has
tripped, or
power outage
has occurred.
Solutions
Turn off the dryer and call
for service.
Turn off the dryer and call
for service.
Check the power supply
or the connection of
the power cord to the
terminal block. Refer to
the Connecting Electric
Dryers section of this
manual for complete
instructions.
Reset circuit breaker
or replace fuse. Do
not increase the fuse
capacity.
If the problem is a
circuit overload, have it
corrected by a qualified
electrician.