Figure 5-10: Secureeasysetup Screen; Figure 5-11: Secureeasysetup Logo; Figure 5-12: Additional Information - Hardware Button; Figure 5-13: Additional Information - Software Button - Cisco Systems LINKSYS WAP54G Guide D'installation Rapide

Wireless-G Access Point
Using the Access Point's SecureEasySetup Feature
Read these instructions before you press any SecureEasySetup buttons. You should locate the SecureEasySetup
buttons of your devices before using the Access Point's SecureEasySetup feature.
NOTE: SecureEasySetup uses WPA-Personal encryption. If your current wireless devices do not
support WPA-Personal security, then you cannot use SecureEasySetup on your network. You will
need to manually configure your network security using the encryption supported by your
existing devices.
1. Before you push any button, locate the SecureEasySetup button for each of your other SecureEasySetup
devices. If you are not sure where to find this button, click Where is my other SecureEasySetup button?
You will see a screen showing the SecureEasySetup logo. Click the Next button to continue or the Close
button to return to the Configure Wireless Settings screen.
You will see a screen with instructions on how to locate the SecureEasySetup hardware button. If your device
does not have a hardware button, it most likely will have a software button. Click the Next button for
instructions to locate the software button, or click the Close button to return to the Configure Wireless
Settings screen.
You will see a screen with instructions on how to locate the SecureEasySetup software button. Click the
Close button to return to the Configure Wireless Settings screen.
Chapter 5: Setting up the Wireless-G Access Point
Using the Setup Wizard

Figure 5-10: SecureEasySetup Screen

Figure 5-11: SecureEasySetup Logo

Figure 5-12: Additional Information - Hardware Button

Figure 5-13: Additional Information - Software Button

14