Publicité
Wireless-G Access Point
Antenna Selection. This selection is for choosing which antenna transmits data, left or right. If you are not sure
which antenna to use, keep the default, Diversity, to increase reception.
Beacon Interval. This value indicates the frequency interval of the beacon. A beacon is a packet broadcast by
the Access Point to keep the network synchronized. A beacon includes the wireless networks service area, the
Access Point address, the Broadcast destination addresses, a time stamp, Delivery Traffic Indicator Maps, and
the Traffic Indicator Message (TIM).
DTIM Interval. This value indicates how often the Access Point sends out a Delivery Traffic Indication Message
(DTIM). Lower settings result in more efficient networking, while preventing your PC from dropping into power-
saving sleep mode. Higher settings allow your PC to enter sleep mode, thus saving power, but interferes with
wireless transmissions.
Fragmentation Threshold. This specifies the maximum size a data packet can be before splitting and creating
a new packet. It should remain at its default setting of 2346. A smaller setting means smaller packets, which will
create more packets for each transmission. If you have decreased this value and experience high packet error
rates, you can increase it again, but it will likely decrease overall network performance. Only minor modifications
of this value are recommended.
RTS Threshold. This setting determines how large a packet can be before the Access Point coordinates
transmission and reception to ensure efficient communication. This value should remain at its default setting of
2347. Should you encounter inconsistent data flow, only minor modifications are recommended.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Click Help for more information.
Chapter 6: Configuring the Wireless-G Access Point
The Wireless - Advanced Wireless Settings Tab
packet: a unit of data sent over a network.
beacon internal: data transmitted on your wireless network
that keeps the network synchronized.
dtim (delivery traffic indication message): a message
included in data packets that can increase wireless
efficiency.
fragmentation: breaking a packet into smaller units
when transmitting over a network.
rts (request to send): a networking method of coordinating
large packets through the RTS Threshold setting.
36
Publicité
Chapitres
Dépannage
