Chapter 5: Setting Up The Wireless-G Access Point; Overview; Using The Setup Wizard; Figure 5-1: Welcome Screen - Cisco Systems LINKSYS WAP54G Guide D'installation Rapide

Wireless-G Access Point

Chapter 5: Setting up the Wireless-G Access Point

Overview

Now that you've connected the Access Point to your wired network, you are ready to begin setting it up. This
Setup Wizard will take you through all the steps necessary to configure the Access Point.

Using the Setup Wizard

1. Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically, and the
Welcome screen should appear. If it does not, click the Start button and choose Run. In the field that
appears, enter D:\setup.exe (if "D" is the letter of your CD-ROM drive).
2. On the Welcome screen, click the Click Here to Start or Setup button if this is the first time you are running
the Setup Wizard. These are your other choices:
Install Linksys Wireless Guard - Linksys Wireless Guard is a subscription service that secures your
network; it is available only in the USA and Canada.
NOTE: The Linksys Wireless Guard service is available only in the USA and Canada.
User Guide - Click the User Guide button to open the PDF file of this User Guide.
Exit - Click the Exit button to exit the Setup Wizard.
Chapter 5: Setting up the Wireless-G Access Point
Overview

Figure 5-1: Welcome Screen

9