Figure 5-4: Power On The Access Point Screen; Figure 5-5: Check The Access Point's Status Screen - Cisco Systems LINKSYS WAP54G Guide D'installation Rapide

Wireless-G Access Point
5. Connect the power adapter to the Access Point and an electrical outlet. Then click the Next button.

Figure 5-4: Power on the Access Point Screen

6. Make sure the Access Point's Power, Act, and Link LEDs are lit on its front panel. If they are not, check your
cable connections. Then click the Next button to continue.

Figure 5-5: Check the Access Point's Status Screen

Chapter 5: Setting up the Wireless-G Access Point 11
Using the Setup Wizard