Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Notes:
• Both memory card slots can be used at the same time.
• When connected to an AC power source by way of the USB-C charging port, 5W is
dedicated to the docking station and connected USB peripherals. The remaining
power is used to charge the connected USB-C device.
• See Optional Accessories section for suggested cables.
• When the unit is connected to the USB-C port on your computer and to a network
via Cat5e/6 cabling, a network connection will automatically be established. If no
connection is made, one can be established manually by going to your computer's
network settings page. For example, when using a Mac, navigate to the Network
section found in System Preferences, click the 'Assist Me' button to get to the
Network Setup Assistant, then follow the prompts to establish a connection.
• If additional power is required for your installation, the U442-DOCK11-S is
compatible with user-supplied 5V DC power jacks equipped with a 3.5 x 1.35 x
9.5 mm output plug with a positive tip and negative sleeve.
1. Connect the built-in USB-C cable to USB-C port on your laptop, tablet or
other device.
2. Use an HDMI cable to connect a monitor or display to the unit's HDMI
port.
3. Connect USB peripherals to the unit's USB-A 3.0 hub ports.
4. For an Ethernet connection, use Cat5e/6 UTP cable to connect to the
unit's RJ45 port.
5. Insert Micro SD or SD/MMC cards into their corresponding slots to
access external memory.
6. Charge a device by connecting a USB-C charger to the unit's USB-C
port. The USB-C port can also be used to connect a USB-C peripheral
device.
02-416-9337BC.indb 5
5
3/8/2018 9:33:47 A
Publicité
Table des Matières
