PowerWalker VFI 1000 LCD Manuel page 128

Step 8: External battery connection (for long-run models only)
Before making external battery connection, please follow below steps to assemble battery
cable.
1
PT
Suggest using AWG12 or 3
2
mm fine-stranded, tip
bonded copper wires.
5
There is a clamp in each
square hole of connector.
Push and hold the clamps
in connector with
screwdrivers (blade with
2.5mm).
9
Follow below chart to make external battery connection.
2
Supplied external battery
connector includes one
connector and one
connector housing
6
After inserting stripped wire
as far as possible, release
the clamp. Then the wire
will be perfect locked in
connector.
Screw the housing to fasten
wires by screwdriver.
3
Open the connector
housing.
7
Recommend to use 2 red
wires as "+", 2 black wires
as "-", and one green or
yellow wire as "GND".
10
7
4
Put copper wires in cable
tie of housing.
8
Clip the housing until latch
clicks.
Suggest using rounded
terminal for external
battery wires.