Hardware Installation; Installing An Hdf3168 Mda Frame - Leviton F3168-22F Manuel D'installation Et D'utilisation

Table des Matières

Les langues disponibles

5 HARDWARE INSTALLATION

Installing the HDF3168 MDA Frame is achieved via securing the frame either directly to the

structural ﬂoor or through a raised access ﬂoor system.

NOTE:

The Leviton HDF3168 MDA Frame Decks, Cross Frame Routing Trays, Front Door Kits

and Cable Clamp Kits are also provided with speciﬁc instruction sheets. Please refer to each

product's provided documentation for further information or access the on our website at www.

leviton.com/HDF3168.

WARNING:

To avoid injury or damage, it is highly recommended that two people perform the

unpackaging, relocation and placement of the HDF3168 MDA Frame. Allow only qualiﬁed

personnel to install this product.

Install a Leviton HDF3168 MDA Frame by following these steps:

5.1.1 Carefully remove the outer cardboard packaging from the frame.

NOTE:

In the event of internal or un-noticed damage to product, save all packaging until

completion of the installation process in the event re-packaging is required.

5.1.2 Remove the frame from the packaging pallet by removing the 4 1/2 .in bolts securing the

frame to the pallet.

5.1.3 Relocate frame to the desired mounting location.

5.1.4 For installation on a Raised Access Floor:

5.1.4.1 Verify the area below the RAF is suitable for cable routing and mounting of

the frame to building structure.

5.1.4.2 Perform the tile cut as shown in Figure 8.

Front of Frame

Figure 8

Table des Matières

Table des Matières