Arcam Solo movie Manuel page 34

System
System Information – Highlight this
Screen Saver –sets the duration of a static
option and press OK to display system
image display before the screen saver is
information.
shown. The options are: 5/10/15/20/25/30
The System Information panel shows
Minutes or Off. Pressing any button on
information about your unit, such as the
the unit or remote deactivates the screen
product name, firmware version, MAC
saver.
addresses and support information.
/
Disc Auto Playback – controls whether
BD-Live Storage – This option allows you
an optical disc (e.g. BD, DVD, CD) will play
to review or delete BD-Live data stored on
automatically after it has beed loaded or
an external USB drive.
after the Solo is turned on.
The options are:
On: Optical discs will play
<
<
automatically.
Off: play must be pressed to play a
<
disc.
<
CEC – The Consumer Electronics Control
(CEC) option is used to allow all supported
devices connected by HDMI to work
together as a single system.
CEC may be turned 'On' or 'Off' , to link or NETWORK MEDIA – The Solo is capable of
unlink the supported devices. playing UPnP content. Note that the Solo
movie will paly both audio and video files,
Firmware Update – If the Solo is
connected to the Internet, you can check whereas the Solo music will play audio
content only. This features can be disabled
for an upgrade to your unit's firmware by
selecting this menu item and pressing by setting it to Off.
OK to highlight 'Network' , then press OK
again.
A message appears if no new firmware is
available, otherwise follow the on-screen
instructions. A message tells you when the
upgrade is complete.
Load Defaults – Press OK with this item
highlighted to reset all system settings
to factory defaults (including parental
controls, radio presets, paired device, etc.).
You are asked to confirm that you want to
load the factory default settings. For 'No'
press OK; for 'Yes' press < then OK.
Settings Menu
System
System
Auto Standby
System
Disc Auto Play
Information: Highlight and press
OK to show file information on the
BD-Live data.
Erase data: Highlight and follow the
on-screen instruction to erase BD-Live System
Firmware Update
storage data.
/
System
Load Defaults
System
System Info
System
Network Media
System settings diagram applies to
OK
E
Auto Standby
[select option]
D
B C
E
Disc Auto Play
[select option]
D
B C
B C
E
Load Defaults
[select option]
D
B C
Software Version
E
WiFi MAC
D Wired MAC
IP Address
B C
E
Network Media
[select option]
D
E-32
5 minutes
10 minutes
15 minutes
20 minutes
B
25 minutes
C
30 minutes
Off
B
On
C
Off
B
Cancel
C
OK
B
On
C
Off