Arcam Solo movie Manuel page 33

administrator. Press OK to save the setting
NOTE
Subnet Mask – Use the cursors to navigate
between segments and use the 0-9 keys
<
on the remote to enter the subnet mask of
your network. Press OK to save the setting.
<
Default Gateway – Use the cursors to
navigate between segments and use
the 0-9 keys on the remote to enter the
<
Internet gateway address. Press OK to save
the setting.
DNS1 – Use the cursors to navigate
between segments and use the 0-9 keys
on the remotel to enter the IP address of
your Primary DNS server. Press OK to save
the setting.
DNS2 – Use the cursors to navigate
between segments and use the 0-9 keys
on the remote to enter the IP address of
your Secondary DNS server. Press OK to
save the setting.
Proxy Setting – If you are accessing the
network using a proxy server, enter its
BD-Live Connection – To set the BD-Live
settings here.
Internet access level.
The access levels are:
Permitted: All BD-Live discs are
<
allowed access to BD-Live websites.
Partial Permitted: Allows Internet
<
access to BD-Live content with valid
certificates only.
Prohibited: Prohibit all BD-Live discs
<
from accessing BD-Live websites.
Settings Menu
Network
The available on-line functions are
disc-dependent.
Refer to the BD-Live disc
instructions for information about
Network
accessing on-line content.
Network Standby
The Solo must be connected to
the Internet and set up correctly
to allow access to on-line content.
See "Network connection" on page
Network
E-13 for network connections
Network Setup
and "Network" on page E-30 for
network settings.
Network
/
Network Information
Network
Net Test
Network
DLNA
Network
Proxy
Network settings diagram applies to
OK
E
Network Standby
[select option]
D
B C
E
Select Interface
[select option]
D
Connection Type
B C
SSID
BSSID
E
Signal Strength
D
Channel
Security
B C
Address Type
IP Address
Subnet Mask
Default Gateway
DNS1
B C
DNS2
E
DNLA
Enable
D
B C
E
Proxy
[select option]
D
E-31
B
Enable
C
Disable
Select SSID
Scan
Enter Password
Enter SSID
WiFi
B
Manual Input
Security
C
DCHP On Enter IP
(Auto)
Ethernet
Enter Subnet
Enter Gateway
DCHP Off
(Manual) Enter DNS1
Enter DNS2
B
Disable
Proxy Host
C
Enable
Proxy Port
None
WEP
WPA-PSK(TKIP)
WPA2-PSK(AES)
WPA/2-PSK(AUTO)