Automatic Time Outs - Cal Spas 2011 Home Resort Fitness 2400 Guide D'utilisation

14
Jets
Press the Jets button:
• Once to activate low speed pump.
• Twice to activate high speed.
• Three times to return to turn pump off.
Light
Press the Light button to turn on the light. Press it
once again to turn the light off. All optional lighting
such as the control panel light and cabinet perimeter
lighting is controlled by the Light button and will turn
on and off with the spa light.
Option
Press the Option button to turn on the pump 2 on.
Press it once again to turn off the pump 2 off.

Automatic Time outs

These features will automatically turn themselves off
during periods of continuous use:
• Low speed pump
• High speed pumps
• Optional circulation pump
• Optional turbo
• Spa light
Setting Filtration Cycles
Your spa is programmed to filter twice a day. The first
cycle will begin 6 minutes after the spa is turned on
and the second cycle 12 hours later. The factory has
programmed the cycle to last for 2 hours but this can
be switched to 4, 6, or 8 hours depending on your
requirements. To set filtration time, turn off the power
to the spa at the time of day you would like one of the
filtration cycles to begin then turn back on after 30
seconds. When power has been restored, press the
"Temp" button then the "Jets" button. Press "Temp"
button again to change the filtering cycle duration.
When desired duration is selected press the "Jets"
button to exit.
At the beginning of each filtering cycle the Turbo system
will run for approximately 30 seconds. The low speed
pump will run for the duration of the filtering cycle
and if an Ozone system is installed it will be activated.
During filtering, "FC" will appear on the main display.
www.calspas.com
After 4 hours
After 15 minutes
After 15 minutes
After 15 minutes
After 15 minutes
2011 Portable Spa
LTR20111001, Rev. B