Biovein Reader (Rs485) - Eden ACCESS-IT UNIT Notice Technique

Technical information ACCESS-IT UNIT

4) BIOVEIN Reader (RS485)

Note: You can connect up to 2 BIOVEIN with an
ACCESS-IT UNIT
(?) Data sheet:
SYT recommended
0.6 mm
2 pairs recommended
Be sure to use the same pair for A and B
Be sure to separate the supply from the RS485 bus
Characteristic: Sensitive connection
Recommended
Screen:
To reach 1,200 m, you must fit a 220 resistor between points A and B at each end of the network (see above).
Attention: To connect the BIOVEIN reader, the version of your C1P2FX control unit must be 2.4 or higher. The
SENATORFX version must be 5.0.7 or higher.
12V DC supply
p.29/42