Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6) BIOVEIN READER (RS 485)
Notice technique / Technical manual - ENCOD-USB – V1.0
6) BIOVEIN reader (RS 485)
Caution:
To connect BIOVEIN readers, your C4PLUSFX central unit must be a revision B model with
version 4.0 or later. The SENATORFX version used must be 5.0.9 or later.
Note:
You can connect up to 4
BIOVEIN readers on each
C4PLUSFX
(?)
Data sheet:
SYT recommended
Ø 0.6 mm
2 pairs recommended
12 V DC power supply
Ensure you use the same pair for A and B
Disconnect the power supply from the bus
RS485
Characteristic:
Screen:
Recommended
To achieve 1200m, you need to install a 220
resistor at each end of the network between
points A and B (see above).
Note:
The total length must not exceed the
recommended distance.
Relay 2
Relay 3
Relay 1
Relay 4
Sensitive connection
p.29/38
Publicité
Table des Matières
