Braun 3 Serie Mode D'emploi page 8

Charging lights (5)
The green charging lights show the charge status of the batteries. The green
charging light blinks when the shaver is being charged or switched on. When
the battery is fully charged, all green charging lights shine permanently,
provided the shaver is connected to an electrical outlet.
Low-charge light (6)
The red low-charge light flashes when the battery is running low.
You should be able to finish your shave.
Shaving (A)
Press the on/off switch (4) to operate the shaver (picture A).
The flexible shaving foils automatically adjust to every contour of your face.
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision setting switch
For precise handling in hard to shave areas (e.g. under the nose) slide the
switch (3) to the right to position . The centre trimmer and one foil will be
lowered.
Tips for the perfect dry shave
For best results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Keeping your shaver in top shape (B)
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Renew, and particularly
when the yellow cleaning light (7) shines constantly after shaving. If this is
not done, the yellow light will go off after some time. The shaver's electronics
will then assume it has been cleaned manually and a new calculation of the
time when the next cleaning is required will be started. During the cleaning
process in the Clean&Renew the yellow light will flash and will go off after
approx. 4 hours when cleaning is finished.
Automatic cleaning
Once the shaver is put into the Clean&Renew, it is cleaned automatically
(see «Clean&Renew (C)»).
8
(3) (390cc/370cc only)