Function Keys - Velleman DVM4200 Notice D'emploi

D indicator for AC voltage or current
E PC-LINK the meter is in the data transmission mode (DVM4100 only)
the meter is in the Auto range mode (automatically selects the
F
range with the best resolution)
G the meter is in manual range selection mode
H maximum/minimum data is displayed
I the meter is in Data Hold mode
J the meter is in Relative Measurement mode
K maximum/minimum peak data is displayed
L sub-display
M low battery indication
N the meter is in Continuity Check mode
O the meter is in Diode Test mode
°C°F
μmAV
P Measurement units
nµmF
MKΩHz
Q second function enabled
R analog bar
S main display
6.3

Function keys

key function
Ω
A mA µA
all
all
all
all
all
all
V, Hz,
Ω, A, mA, µA
24.06.2015
Switch between resistance measurement, diode test and
continuity test.
Switch between DC and AC current.
V Switch between DC and AC voltage.
Switch between °C and °F.
Press to enter/exit Data Hold mode.
Press and hold for ±2s to start hold after a 6 seconds
time out.
Press and hold >2s while switching on the meter to
check LCD. Press again to clear display
Press and hold for ±2s to switch the backlight on/off.
Press to enable second function (peak mode).
Press then press
to exit PC-Link mode.
Press to enter manual ranging mode and to scroll
,
through the different ranges. Press and hold for ±2s to
return to auto-ranging.
DVM4200
Meaning
to enter PC-Link mode. Repeat
8
©Velleman nv