DeFelsko PosiTest CMM Mode D'emploi page 7

Troubleshooting and Returning for Service
Before returning your PosiTest CMM for service, first perform the
following actions:
1. Install new batteries in the proper alignment (pg. 4).
2. Examine the sensor pins and remove any debris or dust.
3. Ensure the concrete surface is bare (uncoated) and free of
dirt, dust, or standing water.
If these steps do not resolve the issue, visit our Service &
IMPORTANT:
Support page for information on returning your Meter for a no-
charge evaluation. See: www.defelsko.com/service.
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTest, PosiTector, and PosiSoft are trademarks of DeFelsko Corporation
registered in the U.S. and in other countries. Other brand or product names are trademarks
or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.
and Limited Liability
www.defelsko.com
© 2021 DeFelsko Corporation USA All Rights Reserved