Connectors And Controls - Rear Panel; Figure 2.6-1: Ac6000 Rear Panel - Enconnex AC6000 Mode D'emploi

2.6

Connectors and Controls - Rear Panel

The AC6000 comes equipped with forced air convection cooling multiple standard
configurations, and is Ethernet or serial compatible.
No. Item
1 Fan
2 Connectors
3 Connector
Switch
4
5 Connector
6 Rail/Mounting
Brackets

Figure 2.6-1: AC6000 Rear Panel

Type Name
Ventilation Cooling
Fan
DB9 RS485.CA
N
Phoenix REPO
(Remote
Power-Off)
Circuit Power
Breakers Switch
RJ45 RS232
Serial
Slide Left & Right
Slide Rails
Rail/Mounting
and
Brackets
Mounting
Brackets
Description
Extracts air from the AC6000 enclosure.
Speed controlled by internal temperature
regulation. Air flows from the enclosure
bezel cold side.
DB-9 female connector reserved for future
use.
Depending on user preference, the ​
feature can be configured in three ways::
1. not used
2. normally open (top two positions)
3. normally closed (bottom two positions)
The default configuration is normally closed.
Provides Input over-current protection as
well as a means to disconnect the input
power from the AC6000
RS232 console for configuration and
monitoring.
Attaches device to slide rails and allows
the AC6000 to be extracted from the
enclosure for service.
R EPO
13