On/Off Cycling Of Compressor; Care And Maintenance - Kobalt XC302000 Manuel D'utilisation

OPERATING INSTRUCTIONS

ON/OFF CYCLING OF COMPRESSOR

WARNING
Risk of Bursting. Drain tank every day to
prevent corrosion and possible injury due to
tank damage. Do not operate drain with more
than 40 psi in tank or drain valve may be
damaged. Drain tank of moisture daily using
the drain valve in the bottom of the tank.
In the AUTO position, the compressor pumps air
into the tank. When a shut-off (preset "cut-out")
pressure is reached, the compressor automatically
shuts off.
If the compressor is left in the AUTO position
and air is depleted from the tank by use of a
tire chuck, tool, etc., the compressor will restart
automatically at its preset "cut-in" pressure. When
a tool is being used continuously, the compressor
will cycle on and off automatically.
In the OFF position, the compressor will not
operate.

CARE AND MAINTENANCE

WARNING
Risk of Explosion. Disconnect,
tag and lock out power source,
then release all pressure from the
system before attempting to install,
service, relocate or perform any
maintenance.
All repairs should be performed by an authorized service representative.
For efficient operation, perform the following maintenance.
NOTICE
Unit care and maintenance. Drain liquid from
tank daily.
NOTICE
Unit care and maintenance. Drain liquid from
tank daily.
15