Malfunctions; After-Sales Service - Fox F28-182A Manuel D'instructions

DANGER:
Before any operation after a malfunction has occurred:
- Switch off the machine.
- Remove the plug from the socket.
- Wait until bandsaw saw blade is still.
After any operation, put all safety devices into service and check them.
PROBLEMS
The engine does not work
Bandsaw saw blade moves
away from the cutting line or
decentralizes itself
Bandsaw saw blade has
broken
The saw blade is misshapen
During work, the bandsaw
stops
Strong bandsaw vibrations:
Aspiration coupling
obstructed
All tools and accessories are made and checked by using the safest and most modern productive methods.
However, if despite these attentions a tool gets damaged, it must be repaired by a Femi authorised after sales
centre.
You can send a request to the e-mail address info@fox-machines.com.

MALFUNCTIONS

CAUSES
A possible tension reduction
has made the
voltage relay start.
Motor overheating, due for
example to a smoothed blade
or to accumulation of saw
dust inside the carter:
Bandsaw saw blade is not
centred on the driving wheel:
Saw blade tension
unsuitable:
Bandsaw saw blade
unsuitable:
Cutting pressure is too high:
Cutting pressure is too high:
Insufficient fastening:
The workbench is loose:
Motor fixing is loose:
No dust collection device is
is
connected or aspiration duct
is too small.

AFTER-SALES SERVICE

EN
SOLUTIONS SUGGESTED
- Re-start the machine.
minimum There is not any supply voltage:
- Check the cable, the socket and the switch.
Find a remedy to the cause of overheating, let
the machine cool down, and then re-start it.
Modify upper wheel angle.
- Adjust saw blade's tension.
is Cutting pressure is too high:
- Reduce the pressure applied to the saw
blade.
- Replace bandsaw saw blade:
- If you must cut a thin workpiece, you must
is
use a thin saw blade.
- If you must cut a wide workpiece, you must
use a wide saw blade.
Avoid to extert a lateral pressure on the
bandsaw saw blade.
- Reduce the pressure you are exerting on the
workpiece.
- Check saw blade sharpness and features.
Firmly fasten the bandsaw to a suitable
ground.
Place the workbench and fix it.
Check lock screws and tighten them if
necessary.
Connect the dust collection device or increase
aspiration power (air speed ≥ 20 m/sec at the
level of the dust collection coupling).
36