Hedge Trimmer Safety Warnings - DeWalt DCHT860 Guide D'utilisation

flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause
irritation or burns.
6) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.

Hedge Trimmer Safety Warnings

• Keep all parts of the body away from the cutter blade.
Do not remove cut material or hold material to be cut
when blades are moving. Make sure the switch is off when
clearing jammed material. Blades coast after turn off. A
moment of inattention while operating the hedge trimmer may
result in serious personal injury.
• Carry the hedge trimmer by the handle with the cutter
blade stopped. Proper handling of the hedge trimmer will reduce
possible personal injury from the cutter blades.
DANGER:
Keep hands away from blade. Contact
with blade will result in serious personal injury.
• Hold the power tool by insulated gripping surfaces only,
because the cutter blade may contact hidden wiring. Cutter
blades contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
• Use both hands when operating the hedge trimmer. Using
one hand could cause loss of control and result in serious
personal injury.
• Keep extension cord away from cutting area. During
operation the extension cord may be hidden in shrubs and can
be accidentally cut by the blade.
• Check the hedge for foreign objects, e.g. wire fences.
CAUTION:
WARNING:
immediately if the extension cord becomes damaged or cut.
WARNING:
contains chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Some examples of these
chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter out
microscopic particles.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
A ................... amperes
Hz ................. hertz
W .................. watts
min ............... minutes
or AC ....... alternating
current
or DC ... direct current
................. Class I
Construction
(grounded)
n o ................. no load speed
................. Class
II Construction
3
Do not expose to rain.
Remove plug from the outlet
Some dust created by this product
(double
insulated)
.../min .......... per minute
RPM ............. revolutions per
minute
................. earthing terminal
.................. safety alert
symbol
CSPM ........... cut strokes per
minute