DeWalt DCHT860 Guide D'utilisation page 15

REPLACE BENT OR DAMAGED
BLADE IMMEDIATELY
It is recommended that sharpening of blades be performed by a
D WALT factory service center. However, blade edges may be
e
sharpened by using a fine tooth file (16A).
1. Run trimmer until cutting
blades (16B) and guard
teeth (16C) are offset
enough so the guard tooth
cannot be touched by the
file. DO NOT file the guard
teeth.
2. Be sure the lock-off lever
is engaged, the blade has
stopped, and the battery
has been removed before
sharpening blade.
3. Wear proper eye protection and gloves, and be careful not to cut
yourself.
4. Carefully file the cutting edges of the blade with a fine tooth file.
File toward the cutting edge (16D) at the original cutting angle (38
degrees from horizontal). File only the straight cutting edges (16D)
of the blades. Do not file where the cutting edge curves into the
center of the blade.
5. Flip the trimmer over to sharpen the bottom blade.
6. Repeat steps to sharpen the opposite side of each blade.
Accessories
WARNING:
with any type of accessory or attachment. Such usage might
be hazardous.
FIG. 16
16C
16A
DO NOT use the hedge trimmer
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D
authorized service center or other qualified service personnel. Always
use identical replacement parts.
Register Online
16D
Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will help you
16B
obtain more efficient warranty service in case there is a problem
with your product.
• CONFIRMATION OF OWNERSHIP: In case of an insurance
loss, such as fire, flood or theft, your registration of ownership will
serve as your proof of purchase.
• FOR YOUR SAFETY: Registering your product will allow us to
contact you in the unlikely event a safety notification is required
under the Federal Consumer Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materials
e
or workmanship for three years from the date of purchase. This
warranty does not cover part failure due to normal wear or tool abuse.
For further detail of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
This warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives
you specific legal rights and you may have other rights which vary in
certain states or provinces.
13
WALT factory service center, a D
e
WALT (1-800-433-9258).
e
WALT
e