Troubleshooting Guide - Polygroup SUMMER WAVES RX600-NF Manuel Utilisateur

WARNING:
UNPLUG THE POWER CORD BEFORE TROUBLESHOOTING THE FILTER PUMP.
SYMPTOM
A Pumptransformernot
Motor fails to
1 start or kicks
on and off
B Low voltage
A Lowpoolwater level
No or slow
water flow
B Inlet/Outlet clogged
2
through the
return fitting.
C Dirtyfilter cartridge
A Chlorine level
B pH level
Filter pumpis
C Dirtyfilter cartridge
not cleaning
D Damaged filter
thepool
3
properly(Cloudy
water,
E Slow water flow
green.....etc.)
F Otherchemicals
G Poolwater verydirty
A Suction/return hose
B Ventscrewin Seal Top
4 Water leakage
C Seal Top
D Baes
POOL PUMP DISASSEMBLY & STORAGE
1. Unplug the Power Filter Pump. Remove the Flow Diverter
and flow plug with Plug 4 .
2. Slowly unscrew the Vent Screw
3. RemovetheSealTop 10 by turning counter-clockwise.
4. Remove the Filter Cartridge 16
5. Loosen all four Hose Clamps 6
6. Clean and dry all filter pump parts includingfilter cartridges.
7. LiberallylubricatetheO-rings 9 attheSealTop10
VentScrew 8 ontotheCanister 13. Storeallpartscarefully.Inaairtightplasticbag.
14

TROUBLESHOOTING GUIDE

CAUSE
A Pump transformer must be plugged into a grounded power outlet.
plugged in
B Check the line voltage, it must be in the range of 215V to 245V (See product label).
A Fillthepooltothefillline. Thesuctionfittingmustbeatleast4"under water.
B Check for obstructions(s) at the suction fitting and return fitting.
C Clean or replace the filter cartridge. A spare cartridge makes service more
A Maintain chlorine level between 1.0 to 1.6 ppm.
B MaintainpHlevelbetween7.3to7.8.
C Cleanorreplacethefiltercartridge.
D Check filter for damage and holes. Replace new filter immediately.
cartridge
E Check for obstructions(s) at the suction fitting and return fitting.
F Have the pool water sample tested by a pool supply store. Obtain opinions
required
G Run pump more often, but never when the pump is in use. Clean/replace
A Tighten the hose clamps. Check the o-rings on the suction/return fittings.
B Check O-ring
C CheckO-ring
D Check O-ring
3 ,Suction Fitting Screen
8 from the Seal Top10 allowing the Filter Pump to depressurize.
and remove any chlorine tablets left inside the core section of the filter.
, remove the Hoses 5 and allow water to drain out.
andGasket 12
convenient.
on additional water treatment chemicals.
filtercartridgemorefrequently.
Check hosesfor damage. Replaceif needed.
9 for damage. Replace ifneeded. TighentheVentScrew
12 fordamage. Replaceifneeded.TightentheSealTop 10.
12 fordamage. Replaceifneeded.TightentheBase 11.
2 and Suction Fitting Base
ontheCanister 13 with petroleum jelly, and then reassemble it along with the Seal Top
SOLUTION
1 from the Return Fitting and Suction Fitting
8 .
10 ,