Polygroup SUMMER WAVES RX600-NF Manuel Utilisateur page 12

1. Check the return fitting on the inside of the pool for correct flow; it should feel like a solid stream of water returning to the pool. You can use the return flow as a
gauge to determine when the filter needs cleaning or replacement. If you feel a reduction in flow, clean or replace filter.
2. Test water and adjust as needed, read - "PUMP WATER CARE". VERY IMPORTANT– FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING IN
POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE AND pH LEVELS ATALL TIMES!
3. The filter cartridge may need to be cleaned and/or replaced several times at start up until the correct chlorine and pH levels are attained. We recommend that you
keep at least one spare filter cartridge on hand at all times. Filter cartridges may be purchased at the store you purchased your pool from, or ordered from Polygroup
4. To turn off the filter pump, unplug the power cord.
5. IMPORTANT: THE FILTER CARTRIDGE MUST BE FIRMLY SEATED OVER THE PUMP INTAKE PORT IN ORDER TO FILTER THE POOL EFFECTIVELY.
6. THEPUMPAND FILTERALONE WILLNOTPREVENTALGAEFROMAPPEARINGAND GROWINGINTHEPOOL;THISCANONLYBEPREVENTEDBY
MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES!
IMPORTANT!
Your filter pump is protected by a thermal switch. The switch senses the temperature of the filter pump. If it gets too hot, the switch will stop the
pumpfrom running untilit cools off. It will automaticallyturn back on whenthefilter pump has cooled down.This isasafety deviceto prevent pump damage and prolong
service life. If your pump is automatically turning off, it is because of high pool water temperature and/or low water flow through the pump. If this happens you need to
check the water flow and correct it if needed, as this filter pump uses the water flow for cooling. Youmay also want to run the pump at night when the temperature is lower.
FILTER CARTRIDGE CLEANING AND
REPLACEMENT
1. Unplug the Power Filter Pump. Remove the Flow Diverter
FittingScreen 2 andSuctionFittingBase
Suction Fitting and flow plug with Plug
1
4
3. Use both hands to twist off the Seal Top
Remove the Filter Cartridge 16 .
10
16
12
FILTER PUMP OPERATION
PUMP MOTOR PROTECTION
3 ,Suction
1 from theReturnFittingand
4 .
1
3
2
4
10 by turning counter-clockwise.
2. Todepressurize the Filter Pump system, vent thefilter pump by twisting
the Vent Screw 8 counter-clockwise.
8
10
4. After you are finished cleaning the filter cartridge, liberally lubricate the
12
GASKET withpetroleumjellyandre-assembleinreverseorder.
Before restarting the filter pump, be sure to remove the PLUG
5. The filter cartridge can be cleansed of coarse dirt and debris by pressure
washinginside andout with a garden hose, makingsure towash between
all pleats. Fine particles of dirt are more easily removed from the filter
pleats whenthe cartridgeisdry.Therefore, after hosing thecartridge,
allow the filter to dry and carefully brush, but do not scrub the pleated
surfaceareas. Cleaningandscrubbinga filtertoovigorously willalsowear
out the cartridge much faster than if it is simply hosed off correctly.
.
®
8
10
4 .