Setup Instructions - Polygroup SUMMER WAVES RX600-NF Manuel Utilisateur

Before assembling your product, pleasetake a few minutes to check the contents and become familiar with all the parts.
WARNING:
POSITIONTHISPRODUCTAWAYFROMTHEPOOL,SOASTOPREVENTCHILDREN FROMCLIMBINGONITANDACCESSINGTHE POOL.
• Allelectricalcomponents must beinstalledin accordancewithstandard NFC 15-100.
• CAUTION:Allfilters comply with the installation standard NF EN C 15-100, stipulating that any electrical device situated lessthan 3.5 metres fromthe pool and
which isfreely accessible must run on low-voltage 12V power.Any electric device powered by 220V must besituated morethan 2 metres fromtheedge of the pool.
Contact the manufacturer regarding any modifications to one or more parts of the filter system.
1. Set up the pool by following all instructions that come with the pool. Do not
fill water until the Filter Pump is properly installed. Locate the Outlet and
Inlet openings onthe pool wall.
Inlet
Outlet
3. Install the return fitting on the Inlet opening of the pool.
3 1
10

SETUP INSTRUCTIONS

2. Install the Suction Fitting on the outlet opening of the pool.
4. RemovetheFilterPump , Hoses
7
the package.
7
2
1
, and Hose Clamps from
5 6
5
6