Startup; Cold Starting; Engine Shut-Down - Beta Motorcycles ALP 200 2020 Manuel

2

STARTUP

Set the fuel tank tap to ON or RES (see page 18).
- Position the key to
(see page 21).
- Make sure the right switch on the handlebar is on
- Check that the gears are in neutral (page 20).
- Pull the clutch lever (page 18).
WARNING!
If you do not pull the clutch lever the vehicle will not start.
- Retract the stand (page 20).
WARNING!
If the stand is not retracted, the engine will stall when the gears are engaged.
ELECTRIC START (page 19):
Push the button until the engine starts. Do not press the button while the engine is
running.
KICKSTART (page 20):
Depress the kick-starter with a sharp movement of the foot.
ATTENTION!
Once the pedal has been depressed, release it immediately. This avoids jolts to the
entire ignition group and to the foot.

COLD STARTING:

Turn on the starter (page 19), when the engine is cold, start the vehicle, wait a
few minutes, then move the starter back to its starting position.

ENGINE SHUT-DOWN

To shut-down the engine, proceed in one of the two following ways:
- turn the key to
- press the button
NOTE:
With the engine stopped, always set the fuel tap to OFF (page 18).
EN
(see page 21).
on the switch unit (see page 19).
32
(page 19)