Pioneer SE-MJ771BT Mode D'emploi page 14

4. Pairing
Pairing must be performed before the headphones can be used to listen to music or
communicate using a Bluetooth device.
For further details regarding the pairing procedure, consult the user's manual for your
Bluetooth device.
(1) Hold the ( ) button depressed while the unit's power is turned off to enter the pairing
mode.
• The pairing mode is confirmed by the LED indicator's alternately flashing blue and
red. (see Fig. 4).
Release the ( ) button after confirming that the LED indicator is alternately lighting
blue and red.
• When in the pairing mode, if pairing is not completed within about 10 minutes, the
power will automatically turn off.
(2) Turn on the power to the Bluetooth device you wish to pair with, and begin pairing;
search for this unit (wireless headphones) from the paired Bluetooth device.
• Set the Bluetooth device close (within one meter) to the wireless headphones.
• These wireless headphones will appear in the Bluetooth device's display as
"SE-MJ771BT".
• For operating details consult the user's manual for the device to be connected.
(3) Confirm that pairing has been successfully completed with the Bluetooth device.
• Look at the display for the Bluetooth-enabled device and select "SE-MJ771BT".
• Pairing is completed if the LED indicator blinks in blue once every three seconds.
• The PIN code for these wireless headphones has been factory set at "0000". Input this
code if requested by the Bluetooth device.
Connect to the Bluetooth device
• Confirm that the power to the wireless headphones is ON before connecting to the
Bluetooth device.
• Depending on the device, connection between the wireless headphones and
Bluetooth device may be effected automatically after pairing.
Disconnecting from the Bluetooth device
• Hold the wireless headphones' ( ) button depressed for about 5 seconds to turn off
the power.
Note
• Depending on the device connected, the A2DP profile may need to be designated
when playing music, and the HFP or HSP profiles for hands-free communication.
• For details regarding operating and setting methods, consult the user's manual for
the Bluetooth device.
• Once pairing has been accomplished, connections will be performed automatically,
but if connection to the device was not successful, perform the pairing operation
again.
• These wireless headphones can record pairing information for up to 8 Bluetooth
devices. If pairing is performed for a ninth device, the information for the first paired
device will be overwritten and lost. If you wish to reconnect to that device on a subse-
quent occasions, it will be necessary to repeat pairing with that device.
• Whenever using a device with which pairing has been performed, first turn on the
power to the wireless headphones, then perform the connection operation for the
paired Bluetooth device.
10
En