Subwoofer Connection - Paradigm OM-105 Manuel Du Propriétaire

PLACINg TWo SUBWooFeRS IN YoUR LISTeNINg RooM
When using two subwoofers, placing one in the front of the room and the
other in the rear of the room (as shown in Fig. 2) usually provides the best
bass performance and sonic integration. Consult the fine tuning section of
the Owner's Manual for more information on adjusting phase settings. If
those locations are not possible or if you want to experiment with placement
options using two subwoofers, the following procedure will be a helpful guide
to achieving better bass performance. Refer to "Subwoofer Connection" then
proceed as follows:
1. Temporarily turn all speakers off (either by turning your amplifier off or
disconnecting them);
2. Connect and place one subwoofer in the central area of your listening room.
Follow directions for connection, as outlined in the following section;
NOTE: The preceding is only a guideline. You may want to use a
bass test disc and SPL meter to more accurately determine the bass
characteristics of your listening room (see Dealer for more information).

subwOOfer CONNeCTiON

SAFETY PRECAUTION: Before proceeding with this
section be sure to read and follow all safety precaution
and instruction notices at the beginning of this manual.
Turn all components OFF before
connecting the subwoofer.
IMPORTANT: It is important that you become familiar with your powered
subwoofer's Input/Output Facilities and Control Facilities. Before connecting
your subwoofer, read the following sections.
INPUT/oUTPUT FACILITIeS
Line-Level Input
q
Allows connection from the Sub/LFE Output of an A/V receiver,
processor, Paradigm X-Series subwoofer control unit (optional) or other
®
suitable low-level source.
3. At a moderately loud level, play music or a video soundtrack with
extended bass that is repetitive or continuous;
4. Walk around your room and note where the bass sounds louder and
where it sounds quieter;
5. Place the first subwoofer within a louder bass area of your room; then
place the second subwoofer within a quieter bass area of your room;
6. Connect both subwoofers and switch all speakers back on; and switch
the amplifier on, or reconnect it;
7. Follow "Fine Tuning" instructions on page 8, to optimize your system's
overall bass performance.
Remember that room acoustics vary so it may take some experimenting
with placement to achieve the best subwoofer performance.
We recommend the use of high-quality cables and connectors when
hooking up your subwoofer (see Dealer).
Facilities vary by model. Inspect your subwoofer's rear panel and check
mark the facilities that apply to your model.
Speaker-Level Input
q
Allows easy connection from the speaker output terminals of an
amplifier or receiver or from the front speakers' hook-up terminals.
6