Using The Snooze Feature; Activating And Deactivating The Alarm; Working With Memory; Storing Stations Into Memory - Eton E100 Mode D'emploi

CLOCK AND ALARM FEATURES
To set the alarm:
1. Turn the radio off. The alarm clock digits (30) appear in the upper
right corner of the display.
2. Press/release the button labeled 'Time Set' twice. The alarm clock's
digits flash in the display.
3. Within 5 seconds, set the hour using the Up/Hour button and the
minutes using the – button. Make sure that AM or PM (29) appear
in the display if your clock is set up in the 12 hr. AM/PM format.
4. Within 5 seconds of finishing, press the 'Time Set' button once or
just wait until the alarm digits stop flashing.

USING THE SNOOZE FEATURE

When the alarm activates and turns the radio on, the alarm activation
symbol (31) appears flashing in the display. While it is flashing,
press/release the SNOOZE/LIGHT button (10). The radio will turn off
and then turn on again in 10 minutes. This process can be repeated
3 times.

ACTIVATING AND DEACTIVATING THE ALARM

The alarm is activated and deactivated by pressing the button
labeled 'Alarm' (9). When it is activated, the alarm activation symbol
(31) appears in the display. When this symbol is not in the display,
it is deactivated. Note that once the alarm turns the radio on, with
the alarm symbol flashing, except for the SNOOZE/LIGHT button,
the radio's controls will not function until the ON/OFF-TIMER button
is pressed.
14
continued
7

WORKING WITH MEMORY

At the factory, the E100 is set up with 8 pages of memory, each
page holding 25 frequencies. This enables storing of 200 frequencies
into memory. This factory setting can be changed and tailored to
your personal needs or can be left as-is. When first learning to store
stations into memory, we suggest using the factory setting. To
change the factory setting, see the section CUSTOMIZING MEMORY
PAGES on page 20. Otherwise, follow the instructions below to store
your favorite frequencies into memory using this original factory
memory set-up.

STORING STATIONS INTO MEMORY

The instructions below show you how to store stations (frequencies)
into the currently selected memory page.
1. Turn on the radio.
2. Tune to the desired station.
3. Press/release the Mem.&Edit button (15). Note that the memory
number digits (38) flash in the upper right corner of the display.
The memory page number, P#, also appears, but does not flash.
4. Within 5 seconds use the numeric keypad to enter the memory
number that you wish to store the station into (In the factory's
original memory setting, there are 25 memories per page. You
would therefore enter a number between 01 and 25).
5. Within 5 seconds press the Mem.&Edit button, or wait 5 seconds.
After a few seconds, the upper right corner's display returns to the clock.
E100 OPERATION MANUAL
15