Autoscan Tuning While In Shortwave; Shortwave Band Chart Of; Clock And Alarm Features; Setting The Clock - Eton YB550 Mode D'emploi

AUTOSCAN TUNING WHILE IN SHORTWAVE

In shortwave, autoscan tuning only autoscans in the short-
wave frequency ranges noted below in the SHORTWAVE
BAND CHART OF AUTOSCANNING RANGES. To tune short-
wave frequencies that are in-between these ranges, or out-
side of these ranges, use one of the other tuning methods.
SHORTWAVE BAND CHART
OF AUTOSCANING RANGES
BAND (meters}
120
90
75
60
49
41
31
25
22
19
16
15
13
11
28
FREQUENCY RANGE (kilohertz)
2250 - 2550
3150 - 3450
3850 - 4050
4700 - 5100
5800 - 6300
7100 - 7500
9400 - 1000
11500 - 12150
13500 - 13900
15000 - 15900
17450 - 18000
18850 - 19100
21450 - 21950
25600 - 26100
Y B 5 5 0 P E
6

CLOCK AND ALARM FEATURES

SETTING THE CLOCK

The factory default has set the clock to function as a 24 hour
format clock. If you prefer a 12 hour, AM/PM clock format,
see the section titled CHANGING THE CLOCK FORMAT, on
page 39.
To set the clock:
1. Turn the radio off. The clock digits appear in the lower
portion of the display (28).
2. Press/release the button labeled 'Time Set' (5). The clock's
digits flash in the display.
3. Within 5 seconds, set the hour using the + button and the
minutes using the – button. Make sure that AM or PM
(29) appear in the display appropriately for the time of
day if your clock is set up in the 12 hr. AM/PM format.
4. Within 5 seconds of finishing, press/release the 'Time Set'
button twice.
O P E R A T I O N M A N U A L
29