Blatchford Elite Blade Instructions D'utilisation page 6

7 Cutting Shin to Length
Note: The following instructions assume the use of the male, sliding, rotating pyramid. If an
alternative adapter is required, this should be taken into account throughout the build process.
Use appropriate health and safety equipment at all times including extraction facilities
1
Cut the blade 10–15 mm longer than required
and assemble fitting clamp (941255).
3
Tighten fitting clamp bolts to 15 Nm
(check each screw at least twice).
5
Remove socket, place fitting clamp in the vice
and cut blade to length. Fit shoulder screws to
prevent damage to components
2
5
4
5
15 Nm
6
6
Fit socket to fitting clamp top housing and
tighten pyramid screws (15 Nm). Refer to
alignment page for initial setup.
Stand user, carry out dynamic alignment and
walking trials. Adjust height to achieve definitive
length with weight evenly distributed.
Drill two 8.1 diameter holes through drill bushes.
4
15 Nm
938295/10-1219