Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
THREE WAY VALVE
BINKS
MODEL 21M
For multiple gun installation, a fluid manifold may be used.
Fluid adjustments are made using the fluid control screw on
each gun. However, when precise fluid control is necessary,
a fluid regulator for each gun must be used.
SOLVENT FLUSH LINE
ATOMIZING AIR SUPPLY
BINKS
MODEL 21
OIL AND WATER EXTRACTOR
THREE WAY VALVE OR
TRIGGERING DEVICE
CYLINDER AIR SUPPLY
Fluid
FLUID SUPPLY
Atomizing
PRESSURE TANK
GENERAL NOTES
1. Have at least 35 PSI air pressure for cylinder operating air.
2. The air line from spray gun to 3-way valve should be as
short as possible for rapid operation.
3. All air used in the spray gun should be dirt and moisture
free. (This is accomplished by using a clean air filter.)
4. Shut off all fluid and air lines to spray gun if spray gun is
to stand idle for any length of time. (This is to prevent
"build-up" or accumulation of minute leaks in the system.)
5. Generally fluid hoses are 3/8" and air hoses are 1/4".
BINKS MODEL 21 & 21V SERIES AUTOMATIC SPRAY GUN
SOLVENT FLUSH LINE
Fluid
ATOMIZING AIR SUPPLY
OIL AND WATER EXTRACTOR
THREE WAY VALVE OR
TRIGGERING DEVICE
CYLINDER AIR SUPPLY
FLUID SUPPLY
3-Way Valve
Cylinder Air
(From Extractor)
PRESSURE TANK
COMPRESSED AIR SUPPLY
Oil and Water
Extractor
Three Way
Valve or
Triggering
Device
Cylinder Air
COMPRESSED AIR SUPPLY
Air
Pressure
Tank
COMPRESSED AIR SUPPLY
Atomizing Air
Cylinder Air
Shut-Off Cocks
Side Port
To Fluid Supply
Control
Atomizing Air
(From Extractor)
COMPRESSED AIR SUPPLY
Fluid Inlet
3/8 NPS(m)
BINKS
MODEL 21
Compressed Air
Supply
Air Compressor
BINKS
MODEL 21
4 / 9
BINKS
MODEL 21
Mounting
Lockscrew
Mounting Hole
(1/2" Dia.)
Atomizing Air Inlet
1/4 NPS(m)
BINKS
MODEL 21
CONNECTION THREADS SIZE
BINKS SPRAY
GUN MODEL
FLUID
21 SERIES
3/8 NPS
Compressed Air Supply
Oil and Water Extractor
Three Way
Valve or
Triggering
Device
Cylinder Air
Atomizing Air
Fluid Supply
Typical Pump
with Container
77-2976-R3.3 (7/2016)
Fluid Adjustment
Control
Cylinder
Operating
Air Inlet
1/4 NPS(m),
(35-50 PSI Min.)
AIR
1/4 NPS
Pump Air
Supply
Publicité
Table des Matières
