Troubleshooting - Ego Power+ HT2400 Guide D'utilisation

TROUBLESHOOTING

PROBLEM CAUSE
◾ ◾
Hedge trimmer
doesn't work.
◾ ◾
◾ ◾
◾ ◾
◾ ◾
◾ ◾
◾ ◾
◾ ◾
Excessive
vibration or
noise.
◾ ◾
◾ ◾
◾ ◾
The battery pack is not
attached to the hedge trimmer.
No electrical contact between
the trimmer and battery
The battery pack is depleted.
The battery pack is too hot.
The hedge trimmer is too hot.
The two switch levers are not
depressed simultaneously.
The blade is jammed.
Dry or corroded blades.
Blades or blade support is bent.
Bent or damaged teeth.
Loose blade bolts.
56V LITHIUM-ION CORDLESS HEDGE TRIMMER
SOLUTION
◾ ◾
Attach the battery pack to the hedge
trimmer.
◾ ◾
Remove battery, check contacts and
reinstall the battery pack.
◾ ◾
Charge the battery pack.
◾ ◾
Remove the battery pack from the tool
and allow it to cool until the temperature
drops below 152°F (67°C).
◾ ◾
Release both switch levers; allow the
trimmer to cool until the temperature
drops below 170.6°F (77°C).
◾ ◾
Depress the switch levers on the front
and rear handle simultaneously.
◾ ◾
Remove the battery pack from the tool,
remove the obstruction carefully, then
reinsert the battery and restart the tool.
◾ ◾
Lubricate the blades, following the
section "LUBRICATING THE BLADE"
found on page 25 in this manual.
◾ ◾
Replace with a new blade or support.
Contact EGO service center for blade
or support replacement service, found
on page 30.
◾ ◾
Replace with a new blade. Contact EGO
service center for blade replacement
service, found on page 30.
◾ ◾
Tighten the blade bolts. Using a 5/16"
wrench, turn the bolt clockwise to tighten.
23