Climadiff Avintage AV7X Notice D'utilisation page 45

the display automatically changes to the highest set temperature of 10°C. Once selected, the display will flash for
approximately 5s before showing the current internal temperature of the cellar. The set temperature can be
viewed at any time by pressing and holding the temperature select buttons.
Press "Set Lower" to set the upper chamber temperature.. The relevant chamber display will start to flash and
each press on the button will alter the temperature by 1°C. Once the lowest set temperature of 10°C is reached,
the display automatically changes to the highest set temperature of 18°C. Once selected, the display will flash for
approximately 5s before showing the current internal temperature of the cellar. The set temperature can be
viewed at any time by pressing and holding the temperature select buttons.
In the event of a power cut, all previously selected temperature settings will be deleted and each chamber will re-
initialise to the factory-preset temperature of 6°C for the upper chamber and 12°C for the lower chamber.
The set temperature can be viewed at any time by pressing and holding the temperature select buttons for 5s.
•
LIGHT control :
1. In order to save energy consumption , the light will be automatically off after 10 minutes when turned on.
2. But if you want to keep the light on permanently, please keep pressing "LIGHT" button for 5 seconds until
the display shows "LP".
3. If you want to reset (automatically off after 10 minutes), please keep pressing "LIGHT" button for 5 seconds
again until display shows "LF".
45