Installation Instructions - Climadiff Avintage AV7X Notice D'utilisation

3° INSTALLATION INSTRUCTIONS
Before using your wine cellar
•
Remove the inner and outer packaging.
•
Before connecting the cellar to the electrical socket, leave it in position for 24 hours. This will reduce the
possibility of malfunction of the refrigeration circuit due to transport.
•
Clean the inside using a soft cloth and lukewarm water.
•
For electrical connection carefully, follow the instructions given in this manual.
•
Unpack the appliance and check if there are damages on it. Do not connect the appliance if it is
damaged. Report possible damages immediately to the place you bought it. In this case retain packing.
•
It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in
the compressor.
•
Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve
sufficient ventilation, follow the instructions relevant to installation.
•
Wherever possible the back of the product should not be too close to a wall to avoid touching or catching
warm parts (compressor, condenser) to prevent the risk of a fire, follow the instructions relevant to
installation.
•
The appliance must not be locate close to radiators or cookers.
•
Make sure that the mains plug is accessible after the installation of the appliance.
Using your wine cellar:
Your wine cellar must be positioned in a room with an ambient temperature between + 16 and +32°C.
If the ambient temperature is higher or lower, the performance of your appliance may be affected and it may not
be possible to obtain temperatures between 5 and 18 degrees.
Installing your wine cellar
•
This wine cellar is designed for free-standing or built-in installation.
•
Position it in a place with sufficient strength to support its weight when loaded. To ensure that it is level,
adjust the height of the feet underneath.
•
To get the best from your appliance with the lowest energy consumption, do not place the appliance
close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do not place it in a
room which is too cold.
•
Connect the cellar to a single socket, leaving a 10 cm gap between the back of the cellar and the wall.
Be careful to support it, so that your wine cellar is perfectly level. (Use of a spirit level is recommended).
This will prevent any movement due to instability, causing noise and vibration, and will ensure that the
door seals perfectly.
43