Instructions For Assembly And Use - Be Cool CLUB Instructions

GB

INSTRUCTIONS FOR ASSEMBLY AND USE

UNFOLD AND USE
1. To unfold Frame: See Fig1-B, release the locked folding latch; Hold handle grip by one hand, push for-
ward away the front leg until more than half has been unfolded; Step down the plastic pedal on cross bars
and lift up handle grips and now the pushchair is fully unfolded. See Fig 1-C.
2. To assemble/disassemble front wheels: Assemble: Align the front wheel house hole with the steel pin as
Fig 2. Slide the wheel upwards and press until the wheel clicks into position. Repeat on both sides. Check
the wheels are secure by pulling gently downwards. Disassemble: Press in the release button and pull
outside wheels set to disassemble.
3. To Assemble the rear wheels: Assemble: See Fig 3, align the rear wheels house holes with rear legs
tubes. Slide the wheels upwards and press until the wheels clicks into position and the spring pins spring
out from the small round holes on the front side of the plastic houses. Check the wheels sets are secure by
pulling gently downwards and checking the spring pins springing out.
4. To assemble/disassemble front bumper Assemble: Align front bumper pegs with the holes on bumper
adaptors. Slide and press into until hear clicks. Disassemble: Press down both side buttons to disassemble
bumper from adaptors.
5.To assemble/disassemble the canopy: Assemble: Align the canopy frame lacths with the plastic spring
house holes on handles. press into until hear "clicks". Disassemble: Press up the plastic spring from the
bottom hole of plastic house,pull outside canopy frame to disassemble.
MAINTENANCE
Do not expose the upholstery material to the sun during long periods.
Wash plastic parts with warm water and soap, then dry all components thoroughly.
14