General Safety Instructions; Safety Instructions For Compressor Operation - Kärcher BOGE CM9 Mode D'emploi

General
Safety instructions for
compressor operation
BOGE Operating instructions for CM 9 series screw compressor module
Allgemeines.pm6.5 - GB
1.1

General safety instructions

Nonobservance of the following safety instructions may lead to injuries
and damage to the compressor.
Also observe the generally valid safety and accident prevention regu-
lations in addition to the information in these operating instructions!
1. Ensure that no commissioning and maintenance work on the compressor
is undertaken until these operating instructions are understood.
2. Only use the compressor for its intended use, as described in these
operating instructions.
3. The owner must ensure
– that only appropriately trained and authorized personnel work on this
compressor,
– that the operating, maintenance and repair personnel has been
made fully familiar with all safety instructions, and that they are being
observed,
– that the compressor is only operated in a safe operating condition.
4. Avoid any operating method which may impair the safety of the com-
pressor.
5. Do not exceed the limit value for the final compression pressure specified
on the type plate.
6. Do not operate the compressor without the attendant protection and
safety devices.
Do not dismantle any built-in safety devices or put them out of operation.
Ensure that all safety claddings and doors are closed prior to commis-
sioning/starting up the compressor and that they are not opened during
operation.
7. Place the compressor out of operation as described in these operating
instructions, when dismantling the safety claddings or safety devices for
repair or maintenance work. Reattach and close all cladding and safety
devices immediately upon completion of the repair or maintenance work.
8 Only operate the compressor using the additional equipment (options)
recommended or authorized by the manufacturer.
9. Undertake conversions and modifications of the compressor only in
agreement with BOGE, taking all relevant safety regulations into con-
sideration.
The manufacturer is not liable for damages resulting from independent
modifications on the compressor.
10. Never start the compressor when one or serveral parts (e.g. cable, plug)
are damaged, when not in perfect working order and when damage is
detected or suspected.
11. Observe all safety and danger signs directly attached on the compressor!
12. The compressed air/oil receiver is subject to "Druckgeräterichtlinie"
(Recommendation for compressors) and has to be checked in prescribed
intervals.
Page 1.1