General Information - Atlas Copco PRO D2112Q Manuel D'instructions

Safety and operating instructions
Maintenance
Good service life and safe function is offered if the
instructions for lubrication, maintenance and over-
haul supplied with the machine are followed.
Use genuine Atlas Copco replacement kits and
parts only.
Warning
Make sure you are familiar with the operating instruc-
tions before you use this machine.
This machine, its attachments and accessories is
intended to be used for drilling, reaming, countersink-
ing.
If using other accessories carefully follow the in-
structions concerning speed limits, support handle
(for taking up sudden reaction forces) as well as
personal protection needed for the application.
For product liability and safety reasons any
modification to the machine, its attachments or ac-
cessories must be agreed in advance with an author-
ized technical representative of the manufacturer.
To prevent personal injury:
Familiarize yourself with the enclosed leaflet
"General Safety Instructions for Drilling and Tap-
ping.
Warning
Dismantling and assembly precautions
The rotor blades (vanes) in the tool have a PTFE
content. The normal Health and Safety recommend-
ations concerning PTFE must be observed when
handling these rotor blades. Particles from wear of
blades might be found in the machine housing or on
the blades. These particles must not get in contact
with open fire. Wash your hands before smoking as
PTFE-particles heated by the glow can produce
fumes which may give rise to allergic reaction.

General information

EC DECLARATION OF CONFORMITY
We, Atlas Copco Tools AB, S-105 23 STOCK-
HOLM SWEDEN declare under our sole responsib-
ility that our product (with type and serial number,
see front page) and in combination with our accessor-
4
ies, to which this declaration relates is in conformity
with the appropriate standard(s):
EN 792-3
and in accordance with the following directive(s):
98/37/EEC
Stockholm, October 2006
Lennart Remnebäck, General Manager
Signature of issuer
Installation
Air quality
• For optimum performance and maximum machine
life we recommend use of compressed air with a
dew point between +2°C and +10°C. Installation
of an Atlas Copco refrigeration-type air dryer is
recommended.
• Use a separate air filter of type Atlas Copco FIL,
removes solid particles larger than 15 microns and
more than 90 % of liquid water, installed as close
as possible to the machine and prior to any other
air preparation unit like REG or DIM (please see
Air Line Accessories in our main catalogue). Blow
out the hose before connecting.
Models which need air lubrication:
• The compressed air must contain a small quantity
of oil. We strongly recommend that you install an
Atlas Copco oil-fog lubricator DIM, to be set
normally at 3-4 drops/min (50mm
cycle running tools, or an Atlas Copco single-point
lubricator type Dosol for short cycle running tools.
For Dosol setting please see Air Line Accessories
in our main catalogue.
Lubrication-free models:
• Regarding lubrication free tools it is, at the cus-
tomers option, no disadvantage if the compressed
air contains a small quantity of oil as supplied
from a lubricator DIM or Dosol.
An exception is turbine tools that should be kept
oil free.
Compressed air connection
• The machine is designed for a working pressure
(e) of 6–7 bar = 600–700 kPa = 87–102 psi.
• Blow out the hose before connecting.
Atlas Copco Tools - 9836 4058 00
D2112Q
3 3
/m ) for long