Checklist - BIG ASS FANS COLD FRONT 100 Manuel De Fonctionnement Et D'entretien

DO
✓ Read the Operation and Maintenance Manual.
✓ Check all hose connections.
✓ Use a 12 gauge cord if the cord is under 50 ft (15 m) or a 10 gauge
cord if the cord is over 50 ft (15 m).
✓ Provide fresh air intake for the cooler and maintain a minimum
clearance of 3 ft (0.9 m) behind the cooler.
✓ Flush new cooling media.
1. Fill the cooler with water.
2. Switch on the pump.
3. Run the cooler without the fan running for at least 5 hours.
✓ Make sure the cooling media is being evenly saturated by using the
control valve to adjust the water flow.
✓ Drain and clean the cooler weekly. Remove the cooling media and
wash with a garden hose.
✓ Use Refresh™ tablets (algae killer) and/or CTT-EC™ cooler treatment
tablets (mineral treatment). Water treatment tablets are available at
bigassfans.com.
DO NOT
Χ
DO NOT forget to dry out the cooling media before shutting down
the cooler. Turn off the pump and leave the fan running for 10 to 15
minutes.
Χ
DO NOT run the pump without filling the reservoir with water first.
Χ
DO NOT completely open the water valve. This may flood the
cooling media.
Χ
DO NOT use a water source with more than 120 PSI of water
pressure.
Χ
DO NOT operate the cooler in a sealed room. Allow for fresh air
intake and exhaust.
WWW.BIGASSFANS.COM

CHECKLIST

© 2020 DELTA T LLC ALL RIGHTS RESERVED.
1