Porter Cable PCC607 Manuel D'instructions page 49

TO REMOVE AN ACCESSORY
Pull the chuck collar (3) away from the
front of the tool, remove the accessory and
release the collar as shown in Figure E.
NOTE: The quick release chuck is spring-
loaded. The accessory will be ejected
when the chuck collar is pulled forward.
E
3
Battery Fuel Gauge - Figure F
The tool is equipped with a battery fuel
gauge (7).
This can be used to display the current
level of charge in the battery during
use and during charging. It does not
indicate tool functionality and is subject to
variation based on product components,
temperature and end-user application.
Checking battery charge during use:
• Press and hold the battery fuel gauge
button (F1).
• The three LEDs (F2) will illuminate
indicating the percent of charge in the
battery (Figure F).
• If LED light does not illuminate, charge
battery.
NOTE: This battery is designed to not
operate when a charge below 20% of
its capacity is reached. After the battery
charge is depleted, the tool will not operate
until after the battery has been recharged.
LED Work Light
There is a work light (8) located near the
battery fuel gauge (7). The work light
is activated when the trigger switch is
depressed, and will automatically turn
off 20 seconds after the trigger switch
is released. If the trigger switch remains
depressed, the work light will remain on.
NOTE: The work light is for lighting
the immediate work surface and is not
intended to be used as a flashlight.
- Figure F
F
F1
Accessories Storage
• A bit storage slot (9) is built into the
base of the tool.
®
The RBRC
The RBRC® (Rechargeable
Battery Recycling Corp oration)
Seal on the nickel cadmium,
nickel metal hydride or lithium-
ion batteries (or battery packs)
indicates that the costs to
recycle these batteries (or battery packs)
at the end of their useful life have already
been paid by BLACK+DECKER. In
some areas, it is illegal to place spent
nickel cadmium, nickel metal hydride
or lithium-ion batteries in the trash or
municipal solid waste stream and the
Call 2 Recycle® program provides an
environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with
BLACK+DECKER and other battery
users, has established the program in the
United States and Canada to facilitate the
collection of spent nickel cadmium, nickel
metal hydride or lithium-ion batteries.
Help protect our environment and
conserve natural resources by returning
the spent nickel cadmium, nickel metal
hydride or lithium-ion batteries to an
authorized BLACK+DECKER service
center or to your local retailer for
recycling. You may also contact your local
recycling center for information on where
to drop off the spent battery. RBRC® is a
registered trademark of Call 2 Recycle,
Inc.
MAINTENANCE
WARNING
serious personal injury, turn tool off and
remove the battery pack before making any
adjustments or removing/installing
attachments or accessories. An accidental
start-up can cause injury.
9
8
Seal
:
To reduce the risk of
F2