Installing The Lanyard; Powering The Unit; Changing/Installing Battery; Charging Battery - RIDGID RT-3 Manuel D'utilisation

This equipment is used to make tem-
NOTI E
perature measurements. Incorrect set up and
use or improper application may result in incor-
rect or inaccurate measurements. Selection of
appropriate measurement methods for the con-
ditions is the responsibility of the user.

Installing the Lanyard

Figure 4 – Installing the lanyard

Powering the Unit

WARNING
To reduce the risk of serious injury during
use, follow these procedures for proper
assembly.
Power is supplied via replaceable rechargeable
battery or the provided USB cable and AC adap -
ter (battery must be inserted).
The thermal imager is equipped with a buffer bat-
tery to maintain system data during power inter-
ruption (such as when the rechargeable battery
is removed changed).

Changing/Installing Battery

1. Switch unit OFF and remove any connec-
tions.
2. Slide the battery compartment cover down to
remove (Figure 5A).
3. Push the battery to release and remove (Fig-
ure 5B).
4. Insert the new battery and slide upwards until
it clicks into place (Figure 5C).
5. Close the battery compartment (Figure 5D).
999-995-119.10_REV. A
RT-3, RT-5x, RT-7x and RT-9x Thermal Imagers
Click
Figure 5 – Installing the Battery

Charging Battery

A new battery should be charged for 3 hours min-
imum before first use. If the battery has been
completely drained, the charging time is approx.
5 hours.
1. Open the USB port cover.
2. Connect the USB cable to the thermal im-
ager USB Interface (Figure 6).
3. If using the AC Adapter, insert the USB cable
into the AC adapter.
4. With dry hands, either
• Insert the AC adapter into an appropriate
electrical outlet.
• Insert the USB cable into a powered USB
Port.
The battery will begin charging automati-
cally.
Figure 6 – Charging the Battery
A
C
B
D
7