Changing The Batteries; Weather Station - OWIM IAN 311249 Instructions D'utilisation Et Consignes De Sécurité

Note: Before mounting the weather station, please close the folding stand
simply pulling it off.
Mark the position of the hole (ø approx. 8 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the screw
Hang the weather station or outdoor sensor by placing the hanging slot
to the according screw.
47

Changing the batteries

Weather station:

Replace the batteries if the LC display becomes illegible or if the battery display
is shown.
Remove the battery compartment cover on the back of the weather station.
Remove the used batteries.
Insert 3 new batteries type AA, 1.5 V.
Note: Make sure that the polarity is correct when you insert the battery. The
correct polarity is shown inside the battery compartment
Close the battery compartment.
36 GB/IE/NI
, into the drilled hole.
45 52
, into the dowel.
44 51
.
40
by
42
,
43
20