Preparing the weather station for use
Removing the battery safety strip:
Open the battery compartment
Pull out the battery safety strip.
Then close the battery compartment.
As soon as the battery safety strip has been removed, the weather station starts to
receive the radio signal.
Note: Do not move the weather station while it is receiving the signal. This may
disrupt reception.
Connecting the weather station with the outdoor sensor and the
DCF radio signal:
After removal of the battery safety strip the weather station attempts to establish a
connection with the outdoor sensor. This process can take a few minutes. The symbol
will keep flashing for few minutes. On successful connection with the outdoor sensor,
the selected channel symbol
outdoor sensor (if necessary you can change the channel of the outdoor sensor as
shown in the section "Setting the channel"). If the connection with the outdoor sen-
sor is not established automatically, this can be done manually as follows:
on the back of the weather station.
40
appears in the LC display with the channel of the
27
GB/IE/NI
15