RCA J22H760 Mode D'emploi page 37

Learning - 42inch
Copying settings out of TV.
Side panel of
the set
Side panel of
the set
2.5mm Stereo Cable
(cross data cable)
Teaching
Placing settings into TV.
22/26/32 inches
Side panel
USB IN
of the set
Teaching
USB Cloner
Learning
Chapter 3
Chapter 3: Using USB Clone Tool
1. Turn TV on.
2. Connect USB Cloner to TV USB Port.
3. Set switch to "learning" position.
USB Cloner
4. Connect 2.5mm Stereo Cable (cross data cable)
Teaching
5. Press the Learn button for 1 second. As soon as
Learning
6. The LED will turn Red and flash while the settings
Note : New TV Settings file, "ChList.bin" will appear
1. Connect USB Cloner to TV USB Port.
42 inch
Side panel
2. Set mode switch to "teach".
of the set
USB Cloner
3. Unplug the TV from the power outlet.
4. Plug the TV back into the power outlet.
Teaching
Note : TV Settings file "ChList.bin" should be present
Learning
(Status LED will Light red without flashing.)
between the TV service port and the USB Cloner
service port.
the LED turns green, release the button.
are being saved to the USB Key. Upon successful
copy, the LED will light up yellow for 2 seconds
and then return to a red, constantly lit state.
Upon an unsuccessful copy, the LED will flash an
error code as described in the "Error Table" sec-
tion.
on the USB Cloner .
(Status LED will flash red)
TV settings will be copied into television.
on USB clone device for teaching function to
work properly. Refer to "Learning" section for
details.
37