Chapter 5: Commercial Interface Menus; Commercial Interface Menus - RCA J22H760 Mode D'emploi

Chapter 5: Commercial Interface Menus

These TVs include a full commercial interface that allows your facility to customize the perfor-
mence to your specific needs. These settings are only accessible to the installer with the use of
the Master Remote(R130K2). Contact your RCA Commercial Distribution to obtain a master
remote.
You can access this menu by pressing MENU -> 9 -> 6 -> 3 -> 2 using the Master Remote.
Commercial Interface
Commercial Interface On
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
ENTER Enter
- You must set "Commercial Interface" to "On" to activate the below items.
Channel
Commercial Interface
Commercial Interface On
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
ENTER Enter
- Direct Tuning Access : If this function is on, you can tune to channels even if the channels are not in the
channel list using the numeric keys. If this function is off, only channels in the channel list can be tuned.
- ATSC Tune Mode : This function sets the channel frequency type for Digital Channels to physical or virtual.
If the facility has a head end signal distribution system, set this to "physical".
- Power On Source : Use this setting to configure the signal source of the TV when it is turned on.
- Power On Major/Minor Channel : Use this setting to configure the initial channel of the TV when it is
turned on.
Note: "Power On Source" should be set to "TV" to use this setting.
To tune to an analog channel, set minor channel to 0.
- Channel Hold : If this function is on then you cannot change channels.
OSD
Commercial Interface
Commercial Interface On
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
Enter
ENTER
- Channel Banner : If this function is off then channel banner will not appear when channel is changed.
- OSD Timer : Use this setting to configure the menu OSD time out.
- Clear V-Chip : This function can be used to Clear V-Chip password and settings.
40
F F G G
G G
G G
G G
G G
G G
G G
G G
G G
Select MENU Exit
Commercial Interface
F F G G Direct Tuning Access
ATSC Tune Mode
G G
G G Power On Source
Power On Major Channel
G G
G G Power On Miner Channel
G G Channel Hold
G G
G G
G G
Select MENU Exit
Commercial Interface
Channel Banner
F F G G
G G OSD Timer
G G Clear V-Chip
G G
G G
G G
G G
G G
G G
Select Exit
MENU
On F F G G
Virtual
F F G G
Off F F G G
2
0
Off F F G G
Select MENU Back
On
F F G G
60S F F G G
On F F G G
Select Back
MENU
Chapter 5