First Run - ACME zoopa Thunder 800 Speedboot Manuel D'utilisation

First run

Firs
Make sure that all tail parts are safely screwed. Also check the tube of the water cooling which leads
out of the boat and the rudder movements.
Place the boat on the water.
Start with reduced speed and drive slowly. Do not drive too far away from the shore.
As soon as you have a safe feeling, you can drive at full speed.
Once you notice the engines running low, you should return the boat to the starting point because the
batterie's capacity is almost empty. Never drain the battery completely. This leads into a deep
discharge.
Once you have returned the boat safely, you should disconnect the battery. Then switch off the
controller. Make sure that no water gets inside, always dry the boat after use.
Controls
Acceleration
To drive forward, pull the trigger/gas lever into your direction. The stronger you pull, the faster it runs.
The model has no reverse gear!
Directions
To drive to the right, turn the wheel forward (clockwise).
To drive left, turn the wheel backwards (counterclockwise).
Break
Stop the boat by pushing the trigger forwards until the center position is reached.
Please note that these directions are described from driver's view – meaning from behind.
If the boat is driving towards you, you need to reverse the commands.
Alternate control
If you prefer an alternate control of the direction commands, you can use the switch ST.REV.
The function of the wheel is then reversed, meaning the boat is driving to the left when moving the
wheel forwards and driving to the right when moving the wheel backwards.
Rudder deflection
If you would like to modify the deflection of the rudder, you can use the steering rate knob that is
located in front of the wheel. Please note: The lower the deflection, the lower the boats latitude. As a
beginner, you can reduce the rate to slowly test the boat. You can higher the rate by turning the switch
clockwise.
Direction- and gas trims
To fine- adjust the L/R- movements, put the wheel into neutral position and push ST.TRIM. Pushing it
down modifies the left- movements, pushing it up adjusts the right- movements.
You can set the gas trims with TH.TRIM. Put the trigger into neutral position and use the TH.TRIM
switch accordingly.
www.ACME-online.de
ACME the game company