Binding Controller And Helicopter; First Flight Preparation; The First Flight - ACME Blizz 200 3D Manuel D'utilisation

3D HELI MASTER
3D HELI Master

Binding controller and helicopter

If you purchased an RTF model, controller and model have already been bound at the factory. If it is necessary to bind the Blizz 200 3D
please follow the instructions below. Before binding, please make sure there are no other helicopters close by. Two or more helicopters
cannot be bound at the same time.

First flight preparation

» Make sure the batteries for both the controller and the helicopter are fully charged.
» Before you switch on the controller, please make sure the TH stick is in lowest position and the TH.HOLD and 3D mode switches are in
lowest idle position (back cover direction).
» Make sure the controller and the helicopter are bound, if not, rebind them.
» Please switch on the controller first, afterwards connect the helicopter's battery with the RX board to bind with the controller.
» After the flight, please cut off the power of the helicopter first, and then switch off the controller.
» Only fly in a suitable area at a safe distance from people, cars, electric pylon, pool etc.

The first flight

If you are not familiar with the controls of your Blizz 200 3D take a few minutes to understand how helicopter reacts before attempting
your first flight.
!
Never fly close to other people! Risk of injury! Only use the model in a free area with a safe distance to road,railway, airports, buildings,
trees, lakes and rivers. Never use in public traffic or car parks when there are parked vehicles.
» Put throttle and trim into the lowest position (lowest idle position).
» Switch on the controller.
» Place the helicopter static level next to the transmitter, then connect the
helicopter's battery with the RX board.
» After a few seconds, the main rotor flaps up and down twice. The receiver
is now bound to the controller. After binding has been finished you can use
the helicopter.
!
Note:
» When binding, please turn off the TH. HOLD switch, or the TX will alarm.
» When binding, please turn off the IDLE switch, or the TX will alarm.
» When binding, please make sure the throttle stick is in lowest position, or
the TX will alarm
22