ACME zoopa Thunder 800 Speedboot Manuel D'utilisation page 15

www.ACME-online.de
Inserting the battery ns
As soon as the charging process is completed, you can insert and connect the battery. First release
the locker on the boat and remove the cockpit. You have now access on the receiver and the
connection cable. Do not plug the battery yet.
Before first use, model and controller need to get paired. This process is only required once and can
be repeated in case of signal loss.
Take the binding cable (included in the bag with the small parts) and connect it to the matching free
port on the receiver. Check the polarity between battery and connection cable and plug those
together. The model includes 2 battery connections which can be used for the LiPo-Twin-Pack-
System. Connect only one battery now.
Switch on the controller and keep pressed the „BIND" button for 5 seconds. The „BIND" button is
located on the right of the controllers LED. Release the button and wait for another 5 seconds. Binding
is successfully completed as soon as the LED on the receiver stops flashing. The model is ready for
use. Make sure to remove the binding cable after this process, else the receiver will start the binding
process again.
Make sure that the switch on top of the controller shows „7:3".
Check the binding by moving the direction wheel on the controller to the left and right. The boats
rudder should move accordingly.
Make sure that all components are stored safely, no dirt gets between seal and model and that
everything is fixed firmly before you close the cockpit.
Please also make sure that no cables may block the engine.
!When switching off, make sure to disconnect the battery before you switch off the controller!
How to use the LiPo Twin-Pack-System
After successfull binding, you can connect the second battery. Simply use the second free connection
port inside the model and make sure that the polarity is correct. The boat will automatically recognize
the second battery.
ACME the game company