Technical Data; Before Starting The Equipment - EINHELL RT-CC 315 U Mode D'emploi D'origine

Anleitung_RT_CC_315_U_SPK1:_
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

AC motor
Power P 1500 W S1 2200 W S6 20%
Idle speed n
0
Carbide saw blade
Number of teeth
Main table dimensions
Sliding table dimensions
Sliding length max.
Cutting height max.
Infinite height adjustment
Infinitely adjustable saw blade angle
Dust extraction connector
Weight:
Operating mode S1: Continuous operation
Operating mode S6 20%: Continuous operation
with idling (cycle time 10 minutes). To ensure that the
motor does not become excessively hot it may only
be operated for 20% of the cycle at the specified
rating and must then be allowed to idle for 80% of the
cycle.
Noise emission values
Operation
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
29.09.2010 8:57 Uhr
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
Keep the noise emissions and vibrations to a
minimum.
230V ~ 50Hz
2,860 rpm
Ø 315 x Ø 30 x 3.6 mm
24
800 x 350 mm
1000 x 300 mm
600 mm

5. Before starting the equipment

73 mm / 0°
49 mm / 45°
0 - 73 mm
0° - 45°
Ø 100 mm
52 kg
Idle speed
93.5 dB 82.1 dB
3 dB
108.8 dB 96.8 dB
3 dB
Seite 23
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
This machine may only be assembled by trained
personnel or other personnel with similar
qualifications.
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Inspect the microswitch of the sliding table
regularly to ensure it works correctly. You are
allowed to operate the saw only when the sliding
table is correctly mounted.
Unpack the bench-type circular saw and check it
for damage which may have occurred in transit.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws, etc.
Before you actuate the On/Off/Emergency switch
(9), make sure that the saw blade is correctly
fitted and that the machine's moving parts run
smoothly.
Check the supplied package to ensure it is
complete (see point 2.4).
GB
23