Optional Sensors - Inficon D-TEK 3 Manuel D'utilisation

15 | Optional Sensors

15 Optional Sensors
Optional sensors are available for use in CO
refrigerant (PN 724-701-G3) applications. To use the CO
sensor, remove the standard sensor and install the new sensor following the
instructions in Removing and Installing the Sensor [} 18]. D-TEK 3 automatically
recognizes the sensor type and the MODE indicator illuminates the appropriate color
to indicate the sensor type the entire time the sensor is installed. Green indicates CO
red indicates flammable refrigerant, and orange indicates the standard refrigerant
sensor is installed.
If D-TEK 3 does not automatically recognize your flammable refrigerant sensor,
contact INFICON to arrange a software test.
The flammable refrigerant sensor does not detect hydrogen, including hydrogen
forming gas.
While searching for CO
avoid exhaling CO
Exposure to high concentrations of CO
be life-threatening.
The instrument is not for use in toxic or hazardous environments. It is not a personal
protection or life-saving device. Always exercise extreme caution in potentially toxic or
hazardous environments.
This product is not intrinsically safe and should not be used in the presence of
explosive fumes, explosive dust, or other explosive chemicals. Use in an
environment with flammable refrigerant concentration approaching the LEL
could cause an explosion or fire resulting in serious injury, death, or damage
to property.
22 / 357
leaks, it is recommended to wear a respirator or mask to
2
toward the probe.
2
WARNING
WARNING
(PN 724-701-G2) or flammable
2
or flammable refrigerant
2
or refrigerants is dangerous and can
2
074-710-P16A D-TEK 3 Operating Manual
INFICON
,
2